Welcome Guest, Log in!
0 item(s)

3M Adhesive Promoter wipe preps

3M Adhesive Promoter wipe preps
Surface Cleaner for better tape adhersion
Your Price: $5.99

Register, to see applicable discounted price $$$ in shopping cart!

Manufacturers Suggest Price:: $6.99
Your Savings: $1.00 (14%)
In Stock
Free Shipping
Part Number:CPW-183-TLI*L-APW-4298

Select here to read more detailed Information

The 3M Adhesive Promoter Wipes prepare the surface for the tape lighting to have a stronger bond.

Application Instructions

The liquid contents of the packet should be completely used as soon as possible after opening. Hold packet upright and avoid squeezing an opened packet to prevent spillage of liquid contents. The packet can be opened by tearing across the top of the packet at the notches. This will expose the sponge applicator. Do not remove the sponge or squeeze a freshly opened packet. Handling the bottom section of the packet should enable application of 3M adhesion promoter 4298 with no mess. Apply a thin, uniform coating to the bonding surface, using the minimum amount that will fully coat the surface. A wet coating thickness of 0.002 inches or less is recommended. Apply promoter only to areas that will be fully covered with tape. Although drying times may vary due to temperature and/or humidity, a drying time of 30 to 90 seconds is typically indicative of this thickness. The primer should be dry before applying tape. For best results, apply tape immediately after primer application or no more than one hour afterward. Be sure the primed surface remains free from contaminants prior to tape application.

Recently Viewed Items