ILLUMRA wireless light switches and controllers allow any light to be controlled from the most convenient location for both commercial and residential applications.
- No Wires,
- No Batteries
- Dimming capability for dimmable capability lighting products
- Control one device (lighting product, motors, etc) from multiple switch locations
These
Controller/Switch sets are perfect for energy-saving applications such as
architectural dimming, daylighting, load shedding, and manual ON / automatic
OFF control. Unlike a traditional dimmer switch, this is an ideal solution where the switch can be mounted anywhere. It is great for retrofit applications. Turn single switch control into multiple switch control for the same device.
The
dimmers are used for custom lighting applications. The wireless dimming
controller (E9X-D02FL) responds to self-powered wireless:
- Self-powered light
switches
- Self-powered wireless sensors
- Wired sensors and
- Wired switches
that
sends a signal to the controller.
ILLUMRA 5A On/Off line-voltage controller allows lights to be controlled by ILLUMRA:
ILLUMRA 600 W Phase Cut Dimming Controller supports forward or reverse phase dimming.
Using the E9X-ER6CD phase adaptive line voltage lighting controller automatically provides reverse or forward phase dimming based on the connected load type. The dimmer makes upgrading to a hybrid lighting system easy by offering phase-adaptive, line voltage dimming for:
- tungsten,
- two-wire fluorescent,
- line-voltage LED,
- electronic low-voltage transformer loads - (120V only).
The Switch or sensor products do not require batteries or wires. The wired dimming controller (NWO-D02FP) also responds to
wired sensors or wired control switches.
LED APPLICATIONS
The
heart of controlling an LED application is using our tiny ILLUMRA PWM Dimming Controller, which is connected to the output of the 12 or 24-volt Constant Voltage Driver before the LED light
application.
The
unit delivers 65,000 PWM dimming steps to provide ultra-smooth dimming
performance through all light levels. These tiny dimmers are 1/2 to 1/4 the
size of other LED dimmers and overcome a significant challenge faced by traditional
LED dimmers; the devices eliminate the issue of choppiness at low dim levels.
Through thousands of PWM dimming steps, the ILLUMRA Constant Voltage LED Dimming Controller creates what the natural eye perceives as a single
continuous dim -- even at low light levels.
Convert Pull Chain Light to Wall Switch with No Wires
Our basic kit allows for mounting a small receiver in the junction box to which the 120V A/C light fixture is attached. The wall switch can be mounted anywhere desired. Pressing on the Dacora wall switch communicates with the receiver and turns on or off the light fixture.
Move a Wall Switch to another location with No Wires
The original switch connection is replaced with the small receiver as above. Then the wireless switch can be mounted anywhere.
[ITEMPRICE]
