LOW VOLTAGE LED TAPE LIGHT
Installation Guide
1.
2.
1. TurnPower Off at Circuit Breaker
4. MountTape Light î‚Dryî‚‚
3.
4.
5. Nev
6.
Cle
Never cut tape light attached to a live circuit. Do not exceed Class 2 Limit.
PeeClean surface before mounting.
Tea
Peel off 3Mâ„¢ adhesive backing. Ensure minimum ambient temperature of 50°F î‚10°Cî‚‚
Adh
or tape light will not adhere properly.
Tear off backing along connector edge.
Adhere to a smooth, dry surface, working from one end to the other, being gentle with
the LEDs.
2. CutTape Light to Desired Length
Cut
Cut at line indicated by Scissor icon.
Mo
5. MountTape Light î‚Wetî‚‚
Mount using included mounting clips/screws. Silicone adhesive can also be utilized to
mount tape light to surfaces.
3. ConnectTape Light to Wire
EnsEnsure polarity matches from the tape light to the wire.
6. TurnPower On at Circuit Breaker
SYSTEM DIAGRAM
Mount using included mounting clips/screws. Silicone adhesive can also be utilized to
mount tape light to surfaces.
The following diagram is an example system design. For information regarding larger
systems or systems not pictured below, please see our web page or contact technical
support. Always review each component installation guide for detailed and up-to-date
wiring instructions. Install in accordance with national and local electrical codes.
Other diagrams will vary based on power and dimming requirements.
Sta
Standard Dimmer System
0-1
Installation Guide
2 2 of 2
|
LOW VOLTAGE LED TAPE LIGHT
|
812024
|
V0.1
2